Pressure switch in hydrogen-powered train ensures safety

In a newly developed hydrogen train for local transport, a pressure switch from WIKA plays an essential role. Within the scope of pressure monitoring, it performs the central safety function in the H2 supply system during the journey.
The advantages of hydrogen in rail transport are rather unknown to everyone. Even if the first trains with H2 fuel cells already are in operation. They are powered by non-electrified railway lines and replace the diesel trains which were used before.
Tanks based on carbon fibre composite technology
The tank convenience of the hydrogen must be adapted to the distances. Among WIKA?s customers has specialised in individual fuel storage systems for H2 vehicles. Their cylindrical tanks derive from carbon fibre composite technology. They are therefore extremely robust and yet have a comparatively low weight compared to steel vessels.
Tanks of this type are also installed in the hydrogen-powered train mentioned at the beginning. This multiple-unit train, designed for commuting traffic, is filled up with the hydrogen at a special terminal. The tank pressure is 300 to 350 bar. While driving, it should be reduced to a single-digit value for the supply to the fuel cell. That is done via a pressure regulation unit downstream of the storage system.
Full in hydrogen-powered train switches the drive system off
Suitable for use in a new kind of hydrogen-powered train with regards to safety ? the model PXA pressure switch from WIKA.
The pressure switch model PXA meets certain requirements of the hydrogen-powered train application. With the monitoring the of tank pressure and pressure regulation in the hydrogen-powered train, the client uses the pressure switch model PXA for the safety function. The miniature instrument switches off the H2 propulsion system in two cases, depending on function:
if the tank is at risk of emptying
if the pressure becomes too high when the hydrogen is transferred to the propulsion system
Such an emergency protection could also be realised with a pressure sensor and a software. But also for trains this solution will be very complicated. Treasure is also rated with a higher risk of error when compared to a switch-based safety function.
SIL-3 approval made the case because of its use
The customer did not decide on the model PXA due to its measurement quality alone. The pressure switch was also considered right for the duty in the hydrogen-powered train because of its SIL-3 suitability. It thus easily meets the safety-related market requirements for the H2 application (SIL-2).
Flameproof enclosure (?Ex d?) and compact design
The PXA in addition has been created for ambient temperatures from -40 �C to +85 �C. In addition, the pressure switch has IECEx approval ?Ex d? (flameproof enclosure), that your customer requires as standard. A further benefit of this instrument: The PXA could possibly be easily integrated into the storage system because of its extremely compact design.
Note
Further information about hydrogen and on the pressure switch model PXA can be found on the WIKA website. When you have any questions, your contact will gladly gelp you.
Also read our posts
Wika develops pressure sensor for hydrogen-powered vehicles
Hydrogen mobility: Clean engines of the future provide same convenience as engines today
Turning hydrogen into kilometres
Hydrogen and pressure sensors ? What must be observed?

Leave a Comment